What Giant Server Farms Teach Homeowners About Cooling 

Share
Tweet
Email

Every time someone streams a movie or backs up phone photos, a building somewhere  has to get rid of the heat that work creates. Large data centers are designed around that  one problem. The methods engineers use to keep thousands of servers running offer  practical lessons for anyone trying to get through a long valley summer without a painful  utility bill. 

Size Matters More Than Power 

Cooling is measured in tons. One ton is the ability to remove 12,000 British thermal units of  heat per hour, and most single-family homes use systems between two and five tons.  Engineers who design large facilities calculate the heat load of every room before choosing  equipment, because an oversized system wastes energy just as an undersized one  struggles to keep up. 

The same rule applies at home. An oversized air conditioner cools the air quickly and shuts  off before it pulls out humidity, a pattern called short cycling. The house ends up clammy,  the compressor wears faster, and costs go up. A load calculation, known in the trade as a  Manual J, accounts for insulation, window direction, ceiling height and local climate. It’s  worth asking for one before replacing any system. 

Keep Hot and Cold Air Apart 

Data halls line up server racks so cold air feeds the front of the equipment and hot exhaust  is captured at the back. When the two mix, the cooling system has to work harder. At  home, the closest equivalent is sealing leaky ductwork, which federal energy guidance  estimates can lose 20 to 30 percent of the air moving through a typical system. Closing  blinds on west-facing windows in the afternoon and leaving interior doors open so return  vents can draw air also reduce the load. 

Watch the Numbers 

Electronics produce a lot of heat. A project like the ENFRA 150 MW data center is being  built with 49,000 tons of cooling capacity, about what more than 15,000 average homes  would use running at once. At that scale, operators monitor temperatures constantly,  because a small drift can damage equipment within minutes. 

Homeowners can do a smaller version of this with inexpensive temperature and humidity  sensors placed in different rooms. A large gap between upstairs and downstairs, or indoor  humidity that stays above 60 percent, points to airflow or sizing problems a technician can 

track down. Federal estimates show that setting the thermostat back 7 to 10 degrees for  eight hours a day can cut heating and cooling costs by up to 10 percent a year. 

Maintenance Runs on a Schedule 

Large facilities don’t wait for something to break. Their maintenance happens on a fixed  calendar. At home, that means changing filters every one to three months, keeping at least  two feet of clearance around the outdoor unit, and rinsing the condenser coils. This  matters more during fire season, when ash and dust can coat the coils and cut efficiency. 

Use the Cooler Hours 

Many large facilities switch to outside air when temperatures drop, a method called  economizing. In dry inland valleys where nights cool off, opening windows after sunset and  running a whole-house fan can pre-cool a home. Closing it up before the morning heat  holds that cooler air longer, so the air conditioner starts later in the day.

Related To This Story

Latest NEWS